How do I reset my Whirlpool Duet front load washer?

Unplug the washer for 30 seconds to attempt to reset the Duet washer control. if your fill hoses have a flood stop check valve turn the water off, disconnect the hoses and run a little water into a bucket. Then reconnect the hoses to your washer and do a Duet Washer Quick Diagnostic Test.

How do you reset the code on a Whirlpool Duet dryer?

If your Whirlpool dryer displays a “PF” error code, indicating a recent power failure, the dryer will need to be reset and restarted. This is done by pressing “Start” for a few seconds to restart the dryer. If the dryer does not restart automatically, select a new cycle and any options then press “Start” to begin.

How do I reset the control panel on my Whirlpool washer?

Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.

What does f1 mean on a Whirlpool Duet washer?

The F01 error on this model washer means the relay for the drain pump motor on the main control board (CCU) has failed to activate or a communication error between the Central Control Unit (CCU) and the EEPROM onboard the CCU occurred.

What is E1 error in Whirlpool washing machine?

E1 – water inlet alarm Check that the drain hose is not below 27½” (700 mm) from the floor.

How do you manually unlock a Whirlpool front load washer?

Hold down the “Control Lock” button on your Whirlpool washer for three seconds at the end of the washing cycle. Listen, and when you hear the unlatching sound, the door should open.

Where is the dryer reset button?

Often, dryers are equipped with a reset button on the control panel.

How do I turn off the control lock on my Whirlpool Duet dryer?

The Easy Fix

1. Locate the “End of Cycle Signal” button. This is located on the right side of the Duet model dryer.
2. Push the button and hold it down for 3 seconds.
3. The Control Lock LED should turn off letting you know that your dryer is no longer locked.

How do you reset a washing machine sensor?

To reset your washing machine, unplug it from the power outlet. Then, plug the washer cord back into the wall. Finally, open and close the washing machine door six times to send the reset signal to the system components.

Why does my washer say F1?

4 Answers. Usually, it’s a problem with the control board. By replacing the control board, you should be able to fix the problem. However, it might also be a problem with the hose, something might be stuck in the hose.